esp8266开发板 在arduino上传错误

Arduino:1.8.12 (Windows 10), 开发板："Generic ESP8266 Module, 80 MHz, Flash, ck, 26 MHz, 40MHz, QIO, 512K (no SPIFFS), 2, v2 Lower Memory, Disabled, None, Only Sketch, 115200"

项目使用了 253060 字节，占用了 (50%) 程序存储空间。最大为 499696 字节。
全局变量使用了27672字节，(33%)的动态内存，余留54248字节局部变量。最大为81920字节。
上传项目出错
error: failed reading byte
warning: espcomm_send_command: can't receive slip payload data
error: failed reading byte
warning: espcomm_send_command: can't receive slip payload data
error: failed reading byte
warning: espcomm_send_command: can't receive slip payload data
error: failed reading byte
warning: espcomm_send_command: can't receive slip payload data
error: failed reading byte
warning: espcomm_send_command: can't receive slip payload data
error: failed reading byte
warning: espcomm_send_command: can't receive slip payload data
error: failed reading byte
warning: espcomm_send_command: can't receive slip payload data
error: failed reading byte
warning: espcomm_send_command: can't receive slip payload data
error: failed reading byte
warning: espcomm_send_command: can't receive slip payload data
warning: espcomm_sync failed
error: espcomm_open failed
error: espcomm_upload_mem failed

在文件 -> 首选项开启
“编译过程中显示详细输出”选项
这份报告会包含更多信息。

你将usb接口拔了再重新上传一下
另外推荐你用另一款软件Mixy，编写代码更迅速，更易理解
如果有用，点击右上角给个采纳哦~

可以看一下你的设置部分吗？另外板子本身引脚链接有没有连好